Polycom SoundPoint IP 501

Revision as of 15:35, 25 March 2015 by 90210chris (Talk | contribs)

Jump to: navigation, search

A quality version of this page, approved on 25 March 2015, was based off this revision.

Configuration Details

Get the IP

Start the Phone and it will get an IP from the DHCP Server, then it will display the IP on the Screen.

Configure Settings

Enter the IP address on your web browser (PC and Device should be on the same network)
The browser should load the configuration page for the IP 501
Click on Sip Link
Enter User and Password (default values are user: Polycom, pass: 456)
Enter the Following values:

Click on Submit. This will save settings and reboot unit.
After the Device has rebooted, click now on Line Link and set your Identification values:

Click on Submit. This will save settings and reboot unit.
After the Device has rebooted, your Device will be ready to be used with VoIP.ms

NOTE: If you have issues reaching an internal extension, make sure to add the following string in your dial plan: [1-9]xx

Please go to the Message Center Section and put the following values.

Subscriber: [blank]

Callback Mode: Contact

Callback Contact: *97

 Please click here to get rid of the MWI Audible Sound