Cisco SPA941
From VoIP.ms Wiki
| [draft revision] | [quality revision] |
m |
|||
| Line 30: | Line 30: | ||
*'''Proxy''': Houston.voip.ms (you server) | *'''Proxy''': Houston.voip.ms (you server) | ||
*'''RegisterExpires''': 180 | *'''RegisterExpires''': 180 | ||
| - | *'''User ID''': Your user ID (123456) main account or sub account (123456_xxx) | + | *'''User ID''': Your user ID (i.e. 123456) main account or sub account (i.e. 123456_xxx) |
*'''Password''': Enter the password that you chose when you signed up your voip.ms service. | *'''Password''': Enter the password that you chose when you signed up your voip.ms service. | ||
*'''Preferred Codec''': G729a | *'''Preferred Codec''': G729a | ||
| + | *'''Use Pref Codec Only''': no | ||
[[File:Linksys SPA941 Configurationjpg.jpg]] | [[File:Linksys SPA941 Configurationjpg.jpg]] | ||
Revision as of 20:47, 6 July 2011
Device Configuration Guides Linksys SPA941 NA
The Linksys SPA941 IP telephone can be configured as a two line or, via a simple software upgrade, a 4 line full phone with pixel based graphical display, speakerphone and headset port.It is configured for DHCP, this means that it gets its IP address from your DHCP server automatically.
STEP 1
Press the Paper "button" and then press number 9 which will take you into the network settings. Option 2 will show you the phone's IP address.
STEP 2
Go to any browser equipped computer on your network and enter the address: http://<IP ADDRESS HERE>/
STEP 3
Click on the "Admin Login" button near the top right side of the screen, then click on the "Ext 1" tab.
STEP 4
You need to modify only a few parameters from the factory default. They are listed here:
- SIP Port: 5060
- Proxy: Houston.voip.ms (you server)
- RegisterExpires: 180
- User ID: Your user ID (i.e. 123456) main account or sub account (i.e. 123456_xxx)
- Password: Enter the password that you chose when you signed up your voip.ms service.
- Preferred Codec: G729a
- Use Pref Codec Only: no
STEP 5
If the second extension is needed, click on Ext2 and repeat Step 4.
STEP 6
You are ready to make some test and calls.
Note: We have seen some customers installing the SPA941 behind a firewall which blocks ICMP packets causes problems with registration. Try turning off anything blocking your firewall.
