Cisco SPA941 - VoIP.ms Wiki

Cisco SPA941

From VoIP.ms Wiki

Jump to: navigation, search

Device Configuration Guides Linksys SPA941 NA


The Linksys SPA941 IP telephone can be configured as a two line or, via a simple software upgrade, a 4 line full phone with pixel based graphical display, speakerphone and headset port.It is configured for DHCP, this means that it gets its IP address from your DHCP server automatically.



STEP 1

Press the Paper "button" and then press number 9 which will take you into the network settings. Option 2 will show you the phone's IP address.

STEP 2

Go to any browser equipped computer on your network and enter the address: http://<IP ADDRESS HERE>/


STEP 3

Click on the "Admin Login" button near the top right side of the screen, then click on the "Ext 1" tab.

Linksys-942-2.gif


STEP 4

You need to modify only a few parameters from the factory default. They are listed here:

  • SIP Port: 5060
  • Proxy: Houston.voip.ms (you server)
  • RegisterExpires: 180
  • User ID: Your user ID (i.e. 123456) main account or sub account (i.e. 123456_xxx)
  • Password: Enter the password that you chose when you signed up your voip.ms service.
  • Preferred Codec: G729a
  • Use Pref Codec Only: no

Linksys SPA941 Configurationjpg.jpg

STEP 5

If the second extension is needed, click on Ext2 and repeat Step 4.

STEP 6

You are ready to make some test and calls.

Note: We have seen some customers installing the SPA941 behind a firewall which blocks ICMP packets causes problems with registration. Try turning off anything blocking your firewall.

Personal tools
Namespaces
Variants
Actions
VoIP.ms Blog
Guides (Français)
Guías (Español)