Telco AC-211
From VoIP.ms Wiki
(Difference between revisions)
| [draft revision] | [quality revision] |
(Created page with "==Configuration Details== '''Web Management''' * Enter the IP in the address bar of your browser for the unit * Enter the password for the unit and click Authencate '''WAN Se...") |
(→Configuration Details) |
||
| Line 22: | Line 22: | ||
**Check "Send Registration Request" | **Check "Send Registration Request" | ||
**Dial Plan: <nowiki>(>#|[2-9]xxxxxxxxx|1[2-9]xxxxxxxxx|0|[489]11|*9[7-8]|*75xx)</nowiki> | **Dial Plan: <nowiki>(>#|[2-9]xxxxxxxxx|1[2-9]xxxxxxxxx|0|[489]11|*9[7-8]|*75xx)</nowiki> | ||
| - | |||
**Transport: UDP | **Transport: UDP | ||
**User/Phone Num: Your SIP Username | **User/Phone Num: Your SIP Username | ||
| Line 46: | Line 45: | ||
'''Reset''' | '''Reset''' | ||
* Click the Reset button to reboot the gateway | * Click the Reset button to reboot the gateway | ||
| + | |||
| + | |||
| + | ==Notes== | ||
| + | * Under the SIP Server Settings the device supports a fail over server, but at this time the server does not support this. Leave this blank or you will have problems receiving incoming calls. | ||
| + | * The dial plan supports 10 & 11 digit dialing, *97 & *98 for voice mail, *75 dialing from the phonebook, 411, 811, & 911. | ||
| + | * When modifying the dialing plan >#| is required at the start of the plan, though I don't know why. | ||
Revision as of 01:28, 17 June 2011
Configuration Details
Web Management
- Enter the IP in the address bar of your browser for the unit
- Enter the password for the unit and click Authencate
WAN Settings
- Go to WAN tab
- Select AutoConfiguration tab and uncheck "Enable Automatic Configuration"
SIP Settings
- Go to SIP tab
- Primary Server: Enter the following.
- Enter the server name. Example: houston.voip.ms
- Port 5060
- Domain Name: voip.ms
- Check "Send Registration Request"
- Dial Plan: (>#|[2-9]xxxxxxxxx|1[2-9]xxxxxxxxx|0|[489]11|*9[7-8]|*75xx)
- Transport: UDP
- User/Phone Num: Your SIP Username
- CallerID Name: Enter the CID you want to send
- Port*: 5060
- AEC On: On
- Authentication User Name: Your SIP Username
- Password: SIP Password
- Click Save SIP Settings
CODECS
- Go to CODECS tab
- Force preferred CODEC Line 1: Set your preferred CODEC, recommended is G711U
- The CODEC set must be enabled in your account: Account Settings -> Advanced
- Click Save CODEC Configuration
Miscellaneous
- Go to Miscellaneous tab
- Enter an NTP server
- Free NTP Servers available at http://www.pool.ntp.org/en/
- Click Save Settings
Reset
- Click the Reset button to reboot the gateway
Notes
- Under the SIP Server Settings the device supports a fail over server, but at this time the server does not support this. Leave this blank or you will have problems receiving incoming calls.
- The dial plan supports 10 & 11 digit dialing, *97 & *98 for voice mail, *75 dialing from the phonebook, 411, 811, & 911.
- When modifying the dialing plan >#| is required at the start of the plan, though I don't know why.
