Polycom SoundPoint IP 501

From VoIP.ms Wiki

[quality revision]

[quality revision]

Revision as of 07:25, 24 April 2011 (view source) LyleDodge (Talk | contribs) m (Changed photo to an actual 501) ← Older edit		Revision as of 19:52, 21 January 2014 (view source) Albert (Talk | contribs) Newer edit →
(One intermediate revision not shown)
Line 28:		Line 28:
-	* Clik on Submit. This will save settings and reboot unit.	+	* Click on Submit. This will save settings and reboot unit.
-	* Afer the Device has rebooted, your Device will be ready to be used with VoIP.ms	+	* After the Device has rebooted, your Device will be ready to be used with VoIP.ms
		+
		+	''NOTE'': If you have issues reaching an internal extension, make sure to add the following string in your dial plan: [1-9]xx
		+
		+	[[category:SIP phones]]

---

Revision as of 19:52, 21 January 2014

Configuration Details

Get the IP

Start the Phone and it will get an IP from the DHCP Server, then it will display the IP on the Screen.

Configure Settings

• Enter the IP address on your web browser (PC and Device should be on the same network)
• The browser should load the configuration page for the IP 501
• Click on Sip Link
• Enter User and Password (default values are user: Polycom, pass: 456)
• Enter the Following values:

• Click on Submit. This will save settings and reboot unit.
• After the Device has rebooted, click now on Line Link and set your Identification values:

• Click on Submit. This will save settings and reboot unit.
• After the Device has rebooted, your Device will be ready to be used with VoIP.ms

NOTE: If you have issues reaching an internal extension, make sure to add the following string in your dial plan: [1-9]xx