Cisco SPA941
From VoIP.ms Wiki
| [draft revision] | [draft revision] |
| Line 3: | Line 3: | ||
| - | The Linksys SPA941 IP telephone can be configured as a two line or, via a simple software upgrade, a | + | The Linksys SPA941 IP telephone can be configured as a two line or, via a simple software upgrade, a 4 line full phone with pixel based graphical display, speakerphone and headset port.It is configured for DHCP, this means that it gets its IP address from your DHCP server automatically. |
| + | |||
| - | |||
| Line 43: | Line 43: | ||
You are ready to make some test and calls. | You are ready to make some test and calls. | ||
| + | |||
| + | Note: We have seen some customers installing the SPA941 behind a firewall which blocks ICMP packets causes problems with registration. Try turning off anything blocking your firewall. | ||
Revision as of 19:27, 2 June 2011
Device Configuration Guides Linksys SPA941 NA
The Linksys SPA941 IP telephone can be configured as a two line or, via a simple software upgrade, a 4 line full phone with pixel based graphical display, speakerphone and headset port.It is configured for DHCP, this means that it gets its IP address from your DHCP server automatically.
STEP 1
Press the Paper "button" and then press number 9 which will take you into the network settings. Option 2 will show you the phone's IP address.
STEP 2
Go to any browser equipped computer on your network and enter the address: http://<IP ADDRESS>/ (where <IP ADDRESS> is replaced by the address that was given to you in STEP 1)
STEP 3
Click on the "Admin Login" button near the top right side of the screen, then click on the "Ext 1" tab.
STEP 4
You need to modify only a few parameters from the factory default. They are listed here:
- SIP Port: 5060
- Proxy: Houston.voip.ms (you server)
- RegisterExpires: 180
- User ID: Your user ID (123456) main account or sub account (123456_xxx)
- Password: Enter the password that you chose when you signed up your voip.ms service.
- Preferred Codec: G729a
STEP 5
If the second extension is needed, click on Ext2 and repeat Step 4. Please make sure to increment the SIP port by one. For example, Ext1 SIP port: 5066; Ext2 SIP port: 5067.
STEP 6
You are ready to make some test and calls.
Note: We have seen some customers installing the SPA941 behind a firewall which blocks ICMP packets causes problems with registration. Try turning off anything blocking your firewall.
