Microsip
From VoIP.ms Wiki
| [draft revision] | [draft revision] |
| Line 46: | Line 46: | ||
In both cases, make sure to wait 3 minutes after setting the caller ID number and trying to dial out <br> | In both cases, make sure to wait 3 minutes after setting the caller ID number and trying to dial out <br> | ||
| - | [[File: | + | [[File:CallerIDnumber.png|500px|border]] |
Revision as of 02:04, 26 July 2023
Tutorial Video
This is the very basic set up for MicroSIP, there are only a few steps needed to have your device up and running. If you wish to improve your softphone performance or enable some features, refer to the advanced section.
Basic setup
1. Download and install MicroSIP from this link.
2. Once downloaded and installed, start MicroSIP and on the welcome screen head onto the arrow pointing down on the top right of the softphone application > Add Account.
3. Fill in the following
Account name: Type your phone number or write any name, it's just an identifier
SIP Server: Type the server of your number, check it out from your portal, i.e. denver1.voip.ms
Username: Type your account number or subaccount name
Domain: Type the server of your number, check it out from your portal, i.e. denver1.voip.ms
Password: Type your password
Display name: Type your name or company name (NOT guaranteed to be displayed)
Finally, press Save and you are done configuring MicroSIP.
4. Go to the dialpad and test the audio dialing 4443
5. Finally, define a caller ID for your username so you can start making outgoing calls:
For the main username: Go to Main Menu -> Account settings -> General tab and fill the "Caller ID number"
For a subaccount/extension: Go to Subaccounts -> Manage subaccount -> Edit subaccount and fill the "Caller ID number"
In both cases, make sure to wait 3 minutes after setting the caller ID number and trying to dial out
