Telco AC-211

[[File:Ac211n.jpg|300px|thumb|left|Telco AC-211]]
<div style="width:100%;overflow:hidden;clear:both"></div>

==Configuration Details==

'''Web Management'''

* Enter the IP in the address bar of your browser for the unit
* Enter the password for the unit and click Authencate


'''WAN Settings'''

* Go to '''WAN''' tab
* Select AutoConfiguration tab and uncheck "Enable Automatic Configuration"


'''SIP Settings'''

* Go to '''SIP''' tab
* '''Primary Server''': Enter the following.
**Enter the server name. Example: houston.voip.ms
**Port 5060
**Domain Name: voip.ms
**Check "Send Registration Request"
**Dial Plan: <nowiki>(>#|[2-9]xxxxxxxxx|1[2-9]xxxxxxxxx|0|[489]11|*9[7-8]|*75xx)</nowiki>
**Transport: UDP
**User/Phone Num: Your SIP Username
**CallerID Name: Enter the CID you want to send
**Port*: 5060
**AEC On: On
**Authentication User Name: Your SIP Username
**Password: SIP Password
**Click '''Save SIP Settings'''

'''CODECS'''
* Go to '''CODECS''' tab
* Force preferred CODEC Line 1: Set your preferred CODEC, recommended is G711U
**The CODEC set must be enabled in your account: Account Settings -> Advanced
* Click '''Save CODEC Configuration'''

'''Miscellaneous'''
* Go to '''Miscellaneous''' tab
* Enter an NTP server
** Free NTP Servers available at http://www.pool.ntp.org/en/
**Click '''Save Settings'''

'''Reset'''
* Click the Reset button to reboot the gateway

==Notes==
* Under the SIP Server Settings the device supports a fail over server, but at this time the server does not support this.  Leave this blank or you will have problems receiving incoming calls.
* The dial plan supports 10 & 11 digit dialing, *97 & *98 for voice mail, *75 dialing from the phonebook, 411, 811, & 911.
* When modifying the dialing plan >#| is required at the start of the plan, though I don't know why.