Zycoo ZP502

From VoIP.ms Wiki

Configuration Details

Step 1

Once you confirm this phone is connected to your network, from your PC ( which should be connected to the network too ), enter the IP address of the wan port in this phone as the URL (e.g. http://xxx.xxx.xxx.xxx/ or http://xxx.xxx.xxx.xxx:xxxx/). If you do not know the IP address, you can look it up on the phone’s display by pressing navigation "down" button.

In the login page you will need to enter the username and password:

1. Default user with general level -> username：guest / password：guest

2. Default user with root level -> username：admin / password：admin

 The default password of phone screen menu is 123. After you configure the ip phone, you need click save button in config under Maintenance 
 in the left catalog to save your configuration. Otherwise the phone will lose your modification after power off and on.

Step 2

Once you enter on the configuration portal of this device, please go to VOIP section, there you can see a screen like this:

First you need to select the SIP line you will use, then you can set the following information on

BASIC SETTING

Server Address: houston.voip.ms( or IP address of any of our servers )

Server Port: 5060 ( if this is blocked on your side, you can try with port 5080 )

Account Name: 1XXXXX or 1XXXXX_X ( here you need to enter your main account or a sub account )

Password : your account or sub account password

Phone Number: 1XXXXX or 1XXXXX_X ( here you need to enter your main account or a sub account )

Enable Register: Mark this box

ADVANCED SIP SETTING

Register expire time: 180

NAT keep Alive interval: 180

Local Port: 5060 ( if this is blocked on your side, you can try with port 5080 )

NAT Keep Alive: Mark this box

Transport Protocol: UDP

Finally, you need to click on button "APPLY" to save these changes.

Step 3 (OPTIONAL)

In case you want to use IAX2 protocol, once you select IAX2 Tab you can see a screen like this:

There you can set the following information

IAX2 Server Addr: houston.voip.ms( or IP address of any of our servers )

IAX2 Server Port: 4569 ( if this is blocked on your side, you can try with port 5080 )

Account Name: 1XXXXX or 1XXXXX_X ( here you need to enter your main account or a sub account )

Account Password : your account or sub account password

Phone Number: 1XXXXX or 1XXXXX_X ( here you need to enter your main account or a sub account )

Local Port: 4569 ( if this is blocked on your side, you can try with port 5080 )

Enable Register: Mark this box

Finally, you need to click on button "APPLY" to save these changes.