ShoreTel

From VoIP.ms Wiki

Revision as of 02:45, 15 January 2016

This guide will cover the basics of getting your ShoreTel phone system working with a VoIP.ms SIP trunk. The ShoreTel documentation is not quite complete, although overbearing, so the purpose of this guide is a quick and dirty to get a trunk up and running and provide you with the couple of little config bits that the ShoreTel documentation lacks.

For this guide, I am using a fresh install of Server2008 with ShoreTel Server 14.2. Server 2008 will need SP1 applied, .NET Framework 4.5 installed, UAC disabled, and all other documented prerequisites fulfilled (SMTP, QWAVE, FTP, IIS, etc) for the installation of ShoreTel Server.

Once ShoreTel Server is installed, navigate to the Director homepage and log in with the default user/pass of admin/changeme

Steps:

- Config SIP profile
- Config trunk group
- config indiv. trunk

Configuring the SIP profile

Under Trunks -> SIP Profiles configure the SIP trunk options as shown in the screenshot. This is the key information which ShoreTel does not include in the built in documentation. RegisterUser defaults to BTN (BillingTelNumber), however this field ONLY accepts 10 digits with no special chars. We need to change this to RegisterUser=UserID, and we will fill in the UserID field later. The rest here is pretty basic, Register=1 causes the trunk to register with VoIP.ms, RegisterExpiration I have set to 60 seconds for NAT keepalive, otherwise inbound calls will fail once the firewall closes the ports.

Configuring the Trunk Group

Under Trunks -> Trunk Groups add a new SIP trunk group from the drop down list.