OBi 100/110

From VoIP.ms Wiki

[quality revision]

[quality revision]

Revision as of 02:59, 22 July 2011 (view source) Cdclark (Talk | contribs) (→Configuration details) ← Older edit		Revision as of 19:31, 24 August 2011 (view source) Ed (Talk | contribs) Newer edit →
Line 1:		Line 1:
	== Configuration details ==		== Configuration details ==
-	Dial **** from the connected phone, then dial 1 to get the IP address of your device.	+	Dial ***1 from the connected phone, to get the IP address of your device.
	'''Service Providers >> ITSP Profile >> SIP'''		'''Service Providers >> ITSP Profile >> SIP'''

---

Revision as of 19:31, 24 August 2011

Configuration details

Dial ***1 from the connected phone, to get the IP address of your device.

Service Providers >> ITSP Profile >> SIP

• ProxyServer: atlanta.voip.ms (one of our multiple servers)
• ProxyServerPort: 5060
• RegistrarServer: atlanta.voip.ms (one of our multiple servers)
• RegistrarServerPort: 5060

Service Providers >> ITSP Profile >> General

• Name: 100000 (Your VoIP.ms username)

Voice Services >> SP Service

• AuthUserName: 100000 (Your VoIP.ms username)
• AuthPassword: ********* (Account Password)

An additional note regarding Outbound Calling

In at least one instance it was necessary to specify a non-default outbound calling route in the Obi110 to be able to place calls using the voip.ms service. The default setting had the Obi110 attempting to place calls using the PSTN port on the device. The relevant setting is:

Physical Interfaces >> PHONE Port

• PrimaryLine: (Select from drop-down)

The default is PSTN. Select SP1 Service if you only have one SIP account configured on the device. Select Trunk Group 1 to have it attempt to place calls using SP1 first, then SP2. Additional Trunk groups can be configured under Voice Services >> Gateways and Trunk Groups.