OBi 100/110
From VoIP.ms Wiki
| [quality revision] | [quality revision] |
Alex.voip.ms (Talk | contribs) |
(→Configuration details) |
||
| Line 22: | Line 22: | ||
[[File:Obisip.jpg]] | [[File:Obisip.jpg]] | ||
[[File:Obipart3.jpg]] | [[File:Obipart3.jpg]] | ||
| + | |||
| + | |||
| + | |||
| + | ''' ''An additional note regarding Outbound Calling''''' | ||
| + | |||
| + | |||
| + | |||
| + | In at least one instance it was necessary to specify a non-default outbound calling route in the Obi110 to be able to place calls using the voip.ms service. The default setting had the Obi110 attempting to place calls using the PSTN port on the device. The relevant setting is: | ||
| + | |||
| + | '''Physical Interfaces >> PHONE Port ''' | ||
| + | *PrimaryLine: (Select from drop-down) | ||
| + | |||
| + | [[File:ObiPhoneport.JPG]] | ||
| + | |||
| + | The default is PSTN. Select SP1 Service if you only have one SIP account configured on the device. Select Trunk Group 1 to have it attempt to place calls using SP1 first, then SP2. Additional Trunk groups can be configured under Voice Services >> Gateways and Trunk Groups. | ||
Revision as of 02:59, 22 July 2011
Configuration details
Dial **** from the connected phone, then dial 1 to get the IP address of your device.
Service Providers >> ITSP Profile >> SIP
- ProxyServer: atlanta.voip.ms (one of our multiple servers)
- ProxyServerPort: 5060
- RegistrarServer: atlanta.voip.ms (one of our multiple servers)
- RegistrarServerPort: 5060
Service Providers >> ITSP Profile >> General
- Name: 100000 (Your VoIP.ms username)
Voice Services >> SP Service
- AuthUserName: 100000 (Your VoIP.ms username)
- AuthPassword: ********* (Account Password)
An additional note regarding Outbound Calling
In at least one instance it was necessary to specify a non-default outbound calling route in the Obi110 to be able to place calls using the voip.ms service. The default setting had the Obi110 attempting to place calls using the PSTN port on the device. The relevant setting is:
Physical Interfaces >> PHONE Port
- PrimaryLine: (Select from drop-down)
The default is PSTN. Select SP1 Service if you only have one SIP account configured on the device. Select Trunk Group 1 to have it attempt to place calls using SP1 first, then SP2. Additional Trunk groups can be configured under Voice Services >> Gateways and Trunk Groups.
