Polycom SoundPoint IP 501
From VoIP.ms Wiki
(Difference between revisions)
[quality revision] | [quality revision] |
(→Configuring Voicemail Messages) |
90210chris (Talk | contribs) (→Configuring Voicemail Messages) |
||
Line 45: | Line 45: | ||
[[category:SIP phones]] | [[category:SIP phones]] | ||
- | Please | + | Please click [http://www.voip-info.org/wiki/view/Polycom+SoundPoint+IP+MWI+audio here] to get rid of the MWI Audible Sound |
Revision as of 15:35, 25 March 2015
Configuration Details
Get the IP
Start the Phone and it will get an IP from the DHCP Server, then it will display the IP on the Screen.
Configure Settings
- Enter the IP address on your web browser (PC and Device should be on the same network)
- The browser should load the configuration page for the IP 501
- Click on Sip Link
- Enter User and Password (default values are user: Polycom, pass: 456)
- Enter the Following values:
- Click on Submit. This will save settings and reboot unit.
- After the Device has rebooted, click now on Line Link and set your Identification values:
- Click on Submit. This will save settings and reboot unit.
- After the Device has rebooted, your Device will be ready to be used with VoIP.ms
NOTE: If you have issues reaching an internal extension, make sure to add the following string in your dial plan: [1-9]xx
Configuring Voicemail Messages
Please go to the Message Center Section and put the following values.
Subscriber: [blank]
Callback Mode: Contact
Callback Contact: *97
Please click here to get rid of the MWI Audible Sound