Cisco Linksys PAP2T - Wiki

Cisco Linksys PAP2T

From Wiki

Revision as of 20:46, 14 June 2011 by Albert (Talk | contribs)
Jump to: navigation, search
Cisco Linksys PAP2T

Configuration Details

Step 1

The first step is to find out what IP Address your adapter is currently using. To do this, pick a phone connected on Line 1 and do the following:

Dial: **** (That is 4 asterisks)
Once this is done, dial: 110# (110 followed by a square)

The system should now playback the IP Address your device has been assigned.

Step 2

Using your favorite web browser from a computer on the same network, point the address to the IP address of your adapter.
(example Replace by the IP Address your device is currently using.

Step 3

You should now see the web interface of your Linksys/Sipura.

click on the link "Admin", and once the page has reloaded, click again on the link "Advanced View".

Step 4

Under the LINE 1 Tab, Find the following fields and fill them with the following information

Proxy: (one of our multiple servers)
Display Name: John Smith (your name or company name)
User ID: 100000 (your username)
Password: ******** (the account password)
Register Expires: 180
Proxy Fallback Intvl: 180
Nat Keep Alive: Yes
Nat Mapping/Traversal: Yes

Step 5 (Optional)

Optionally, To save bandwidth, you can change Line 1 "Preferred Codec" to G729a and make sure "Use Pref Codec Only" is set to no.

Step 6 (Optional)

Optionally, you can configure your adapter with a better dial plan, allowing faster dialing of 10 digits number (Local US/Canada) and also enable 7 digits dialing in one area code of your choice.

At the bottom of Line 1 TAB, you will find a field called Dial Plan

Replace the 555 digits in the following line by the area code of your choice and copy the line, including parenthesis, in the Dialplan field in Line 1 Tab at the bottom of the page:


Step 7

Click on the "Save Settings " button at the bottom of the form.

Configuration Screens

PAP2T Configuration Screen

PAP2T Configuration Screen

PAP2T Configuration Screen

How to avoid the long delay to hear the ringtone

With the default setting in this device you need to wait about 10 seconds after dialing before your call goes out. To resolve this problem, change the PAP2's Interdigit Long Timer. For instructions on how to do this please follow the steps below.


Another alternative is only append # after all your outgoing calls (e.g. 5554441234#). This will bypass the Interdigit timer completely and your call will go out immediately.

Personal tools
Actions Wiki
Guides (English)
Guides (Français)
Guías (Español)