Cisco SPA112

2012-04-10T13:54:47Z

Paborn: /* Configuration Details */ added link to IVR codes

[[File:SPA112.jpg|300px|thumb|left|Cisco SPA112]]
<div style="width:100%;overflow:hidden;clear:both"></div>

'''Make sure to install the latest firmware from http://www.cisco.com/go/smallbizvoicegateways.'''
'''Version 1.1 or later should be used for proper Caller ID support. '''

== Configuration Details ==
'''Step 1'''

Attach the Cisco SPA112 to your network and attach an analog phone to one of the phone ports, then do the following:
Dial **** from the phone, even though there is no dial tone.
When you hear "System Configuration Menu," dial 1 1 0 # slowly.
The current IP address will be read back.

'''If you hear 0.0.0.0, check your network connection and DHCP server. If necessary, a static IP address'''
'''can be assigned by using option 111# at the IVR, then entering the IP address with your phone's keypad'''
'''(for example, 10*1*27*2 for 10.1.27.2). The network mask can be set with option 121# and the default'''
'''gateway can be sent with option 131#''' Learn more about the IVR menu options from the https://supportforums.cisco.com/docs/DOC-9900 document.

'''Step 2'''

Open your web browser and go to the IP address you obtained in step 1 (for example, http://10.1.27.1).
The default username is admin, and the default password is also admin.

'''Step 3'''

[[File:SPA112_Quick.PNG]]

Go to Quick Setup and configure Line 1 as follows:

'''Proxy:''' server_location.voip.ms

'''Display Name:''' Your name

'''User ID:''' Your VoIP.MS SIP Account number (or subaccount)

'''Password:''' Your VoIP.MS SIP Password

'''Dial Plan:''' (911S0|<:1555>[2-9]xxxxxx|1[2-9]xx[2-9]xxxxxxS0|[2-9]xx[2-9]xxxxxxS0|*xx|*xx.|[3468]11|822|0|00|[2-9]xxxxxx|4xxx|**275x.|xxxxxxxxxxxx.)

(note: replace 555 in the dial plan with your area code)

Click Submit to save settings.

'''Step 4'''

Click on Voice, then Line 1

Set '''NAT Mapping Enable''' to Yes, then set '''NAT Keep Alive Enable''' to Yes. If your environment does not use NAT, you can leave these settings disabled. These features can usually be disabled on the SPA122 if it is connected directly to your modem since its' traffic will not be subject to NAT in this configuration.

Under '''Proxy and Registration''' set '''Register Expires''' to 180, '''Proxy Fallback Intvl''' to 180

[[File:SPA112_NAT1.png]]

[[File:SPA112_Proxy1.png]]

Also confirm the following settings:<br>
'''Use DNS SRV:''' NO<br>
'''DNS SRV Auto Prefix:''' NO

Click Submit to submit these changes

'''Step 5'''

Click '''Network Setup''', then go to '''Basic Setup''', then click '''Time Settings'''

Set your time zone and (optional) NTP settings. A good time server choice is 0.pool.ntp.org. Setting the proper time zone will ensure that the time which appears on your Caller ID display is correct.

Click Submit to save the changes
[[category:Analog Telephone Adapters]]

VoIP.ms Wiki - User contributions [en]

Cisco SPA112